3D configurators and virtual showrooms · Barcelona

3D configurators and virtual showrooms for manufacturers in Barcelona

3D configurators and B2B virtual showrooms for manufacturers in Barcelona and its metropolitan area. We are in Poblenou, so meeting in person is easy when it helps: validating materials, measuring a part or sitting down with the team. The rest of the project runs remotely.

10 yearsproducing 3D for architecture, interiors and products
200+clients advised
150 TBof models processed
3configurator technologies: images, WebGL and pixel streaming

Frame Slate Stone · Backrest Charcoal · Seat Charcoal · Straps Cotton

What we do

What we do with a Barcelona manufacturer

We design and build 3D software for manufacturers: configurators that respect factory rules and showrooms that bring order to the collection for distributors and specifiers. Being close serves one purpose: resolving sooner the doubts a file cannot explain.

Outdoor dining set with woven chairs in a stone courtyard
When it pays off

When it pays off to start here

It pays off when the catalogue grows faster than the ability to photograph it, when the sales network sells with screenshots and emails, or when distributors need sheets and downloads that exist nowhere in one place.

Upholstered bar stool with black steel legs
Ways to start

Three ways to start without committing the whole catalogue

You do not have to digitalise the entire catalogue to find out whether it pays off. You can start with a review, a pilot on one family, or a full project. The difference is how much gets validated before you invest and when the first version goes live.

Possible scopes and what each one validates
ScopeWhat it includesWhat it validates
Catalogue reviewFamilies, variants, CAD and rulesWhether 3D pays off and where to start
One-family pilotGeometry, materials and rules for one familyReal performance and team acceptance
Full projectCatalogue, integration and per-channel accessDaily selling without the PDF
Process

From the first meeting to the web in four steps

The project runs in stages and each one is validated before the next. First scope and family, then geometry, then rules and materials, and finally publishing and integration with your system.

  1. 01

    We look at the catalogue

    We review families, variants and available CAD. We leave with one family and the order the rest comes in.

  2. 02

    We build the geometry

    We import your CAD or model from drawings, photos or the part. Target: under 5 MB and 60 fps on mobile.

  3. 03

    We write the rules

    What combines, which sizes are valid and how price changes. We test them with the people who sell.

  4. 04

    We publish and integrate

    Configurator or showroom on your site, connected to ERP, CPQ or store. Code and models in your hands.

Frequently asked questions

Where are you, and can we visit?

The office is at Carrer de Pujades 94, in Poblenou, Barcelona. Meetings are arranged in advance by email or through the form. We also go to the factory or showroom when the project needs it.

Do you run workshops in person with the team?

Yes, when they help. Half a day is usually enough to align scope, review materials and try the configurator with sales. The rest of the reviews happen remotely.

Do you work with factories outside Barcelona?

Yes. We work with manufacturers across Spain and beyond. Proximity speeds up some decisions, but the method is the same: CAD, remote review and visits only when they add something.

How much does it cost, and who owns the code?

It depends on the products and variants, the models to be built or adapted, and the integration. After a 30-minute call we send a fixed proposal. The code and the models are 100% yours.